4 fixed-partitions partitions found on MTD device spi0.0 Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled pinctrl-single 1804002c.pinmux: 576 pins, size 72 jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. squashfs: version 4.0 (1) Phillip Lougher workingset: timestamp_bits=14 max_order=14 bucket_order=0 UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear) UDP hash table entries: 256 (order: 0, 4096 bytes, linear) TCP: Hash tables configured (established 1024 bind 1024) TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear) TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear) tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear) IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear) clocksource: Switched to clocksource MIPS pinctrl core: initialized pinctrl subsystem futex hash table entries: 256 (order: -1, 3072 bytes, linear) clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns dyndbg: Ignore empty _ddebug table in a CONFIG_DYNAMIC_DEBUG_CORE build Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear) Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear) sched_clock: 32 bits at 325MHz, resolution 3ns, wraps every 6607641598ns clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5880801374 ns SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 mem auto-init: stack:off, heap alloc:off, heap free:off Inode-cache hash table entries: 4096 (order: 2, 16384 bytes, linear) Dentry cache hash table entries: 8192 (order: 3, 32768 bytes, linear) Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2 Built 1 zonelists, mobility grouping on. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Initrd not found or empty - disabling initrd SoC: Qualcomm Atheros QCA9533 ver 2 rev 0 # Giving linux memsize in bytes, 67108864 # Transferring control to Linux (at address 80060000). Image Type: MIPS Linux Kernel Image (lzma compressed) *** Warning - bad CRC, using default environment Reserving 128k for boot params() at: 83f83fb0įlash Manuf Id 0xc8, DeviceId0 0x40, DeviceId1 0x17 Reserving 36 Bytes for Global Data at: 83fa3fb0 Reserving 44 Bytes for Board Info at: 83fa3fd4 Top of RAM usable for U-Boot at: 84000000 I've gotten to the point where if I interrupt the autoboot in u-boot, and then run the bootcmd manually, it works flawlessly, but if I let it autoboot on its own eth1 fails to initialize.Īutoboot: U-Boot 1.1.4-LSDK-10.2-00082-4 (03:51:37)Īth_ddr_initial_config(234): (16bit) ddr2 init I'm trying to add support to a new device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |